A chamber with 3 large lasers in pitch dark, all lights off. There are 3 control panels. One is the laser panel, control laser power. LASER WILL GAIN PRESSURE THROUGHOUT OPERATIONS. PLEASE REMEMBER TO VENT EXCESS STEAM BY TYPING “Vent laser steam”. FAILURE TO VENT WILL CAUSE LASER FAILURE AND REACTOR SHUTDOWN. The second panel is Reactor controls. There’s the startup, shutdown, and reactor stall reboot. The last panel is coolant controls. Meltdown occurs when temperatures exceed 25,000°F and when the shield hits 0% When temperature exceeds 3000°F, the shield will slowly degrade by 1%. During meltdown, a shutdown will be mandatory, to shutdown, regulate all 3 lasers to 20% output. Each laser will suddenly increase or drop in power, to regulate, type “Lower laser output, or increase laser output” The laser output bar will increase by about 1 or -1. Once regulated, type “Attempt shutdown.” Shutdown chances may vary on how fast you shut it down. If shutdown fails, evacuate. When temperature drop below -50°F, a stall will occur and the lasers will shutdown, simply type “reactor stall reboot”. To start reactor startup, type “Startup”

SYSTEM: Waiting for reactor startup.

Reactor shield: 100%

Lasers 1: 0 PSI Lasers 2: 0PSI Lasers 3: 0PSI

Lasers 1: Output 0 Lasers 2: Output 0 Lasers 3: Output 0

Coolant: offline

Temp: 68°F